Activity Stream

Late reply...... Yea im down for a meet up! I live in the I.E. get every other weekend off and can pretty much drive wherever in my SC. Lets get 1...

https://www.willtheyfit.com Enter your old wheel/tire specs and your new wheel/tire specs and this will compare the fit.

Copper RTV spec sheet says this about that: "Chemical / Solvent Resistance The product retains effective properties in contact with most shop...

Can electronic contact cleaner eat copper rtv? Saw someone else using it on here to check for vacuum leaks. I sprayed the IC piping then checked...

Redoing the entire exhaust system on my 91 SC. New headers are out for ceramic coating now. David

Need to get codes ran again and post the numbers here. Should be 3 digit codes. You can pick up a code reader like this on Amazon, Ebay or at...

I guess it's a basic chip from supercoupesunlimited. Once again, it did fine before, so this time I really messed something up.

What type of tuning or chip are you using ? Asking because it would run pretty crappy on stock tune with long tubes and 38# injectors. David

You guys can plan to see me there Friday thru Sunday!

I meant bare metal where that large accessory bracket attaches to the front of the engine. The DIS -does- need the silicone paste that comes with...

Well, that's definitely a possible issue on the DIS part. I put thermal paste on the mounting surface, thinking like its a computer part or heatsink....

scskydivin, Looks like it's 10. I am in for 2 of them if available. Just contact and let us know next move. Thanks

SCs live/die by their electrics/electronics. A compromised harness can include visual damage as well as hidden. Some wires are shielded to fight off...

The ol' girl is an '89. The harnesses are, in my opinion, not the best looking. I know one plug has one wire that is bypassing the plug itself(the...

At least it's something to go on ;) Like I said...don't keep firing the parts cannon at it. Might be wiring/harness. Inspect the harness for the...

Spark plug wires match firing order. Unplugged the cam sensor and it wasn't as hard as I was imagining it would be to start. It seemed to run a...

This looks like the list of folks that want one of these. My count is 9 parts, 10 if XB-70 wants 2 of em. I'll assume that unless we hear from...

Sounds like DIS or coil pack problem or any connection between them. Once had an idle stall problem which turned out to be the sc belt rubbing on...

Disconnect the cam sensor and try to fire it up...might take more than one try. See if it runs differently/better. Double check plug wire layout:

New spark plug wires didn't seem to help, but now I only have one code. Code 19(Distributorless Ignition Cylinder identification circuit failure)....

Any word on these? I'm almost to the point that I need it. If we don't order soon then I'm probably out. I can just make one but if I can get one...

<img src="https://vgy.me/nxitNE.jpg" alt="nxitNE.jpg"> Let the games begin

Got the garage cleaned up and brought the silver car in for the motor swap. <img src="https://vgy.me/16xg6S.jpg" alt="16xg6S.jpg">

My fuel rails have arrived! <img src="https://vgy.me/tFMAdv.jpg" alt="tFMAdv.jpg">

(2)3.8 SC’s one broke down, one intake to oil pan. Blowers, piping, etc available. Brackets, new crank balancer/pulley. M5R2, AOD Transmillons &...

First project was done today. Vogtland 1.6" Lowering Spring

Haha, sorry. I meant the SC. I'm sure the BelAir does get way more attention, but I drive an SC because it gets MY attention. :D

Nice - sounds good from here...thanks for sharing.