View Full Version : Technical Forum
- so freakin close- after 3 years - long
- ARP Main studs
- Developed a horrible vibration in the car
- abs motor to pump seal
- Lower shock mount bushings(rear)...replaceable?
- Busted Oil Cap?
- Bad Motor Mount symptom?
- How do u get to the spark plugs?
- seat belt not working
- c4 vs 5 speed
- c4 vs 5 speed
- Head Bolt Pt # question
- 42,s, 10%, 75mm tb, 94-95 blower.. how much HP gain?
- brakes
- Exhaust Question
- Can't figure it out!! Help!
- SC died while driving?
- Hmm...trying to figure out if this caused my blown hg's.
- Trunk seal
- '94 long block in '89
- Must know right now! easy question
- wont start....
- Torque spec for converter nuts
- Head Gaskets
- Idle Problem
- Brake problem
- Time for motor mounts.......
- What are these beeps?
- 5 speed swap
- Griffin universal-fit part number...
- 1/4" play in steering
- Source - ARP Head Studs
- SC and LX A/C compressor
- NOS Jetting
- What is this?
- Computer swapping?
- Trailer hitch?
- Nitrous and HG questions
- 89 SC Mucho Big Problem
- 5 speed manual from a 88 turbo coupe
- Fuel Injector O-rings
- Steering Rack Question
- which radiator
- Anyone using 245/50/18
- Are my front suspension bushings junk? *Pics*
- Did I make a mistake going with 20W50 on my 170k+ engine?
- Best Way To Remove Dashboard Top
- 95 Mustang SC
- EGR Hose
- Head Gasket question....
- Boost falling off
- EGR delete pics
- What error code it this?
- coolant leak?
- 89 SC trans to 95 Stang??
- Wheels/Tires sizes
- 5spd computer vs auto?? any difference?
- Coolant Leak....
- Snout Seal
- Air filter
- clutch line help
- Engine swap
- Engine wiring ? and ic tube ?
- VMM and Oil Change Now
- eaton m90 rebuild
- A couple problems, need a little advise!!!
- Haven't Started it in a while...
- Engine Idles Rough and CEL Comes On....
- Exhaust length reduction question
- Coated Rotors
- IC teflon gasket thickness
- Help
- couple of pics of me messin around with some 3.8 heads.
- HELP! My SC won't start!
- Fuel Regulator or Injectors?
- sweet story
- Visual difference 89-93 Supercharger vs 94-95
- 35th anniversary wheel centers...
- Bigger MAF -> MAF voltage low error?
- Custom mounting for an Aluminum Radiator
- whats this connector for?
- ARP Moly Lube
- Ques. about a SC.
- sc wheels
- early model pulley on a 94-95 blower.
- Power Steering pump-How hard is it to replace it?
- Subframe Connectors?
- Check engine light
- Blower Rattle
- Engine oil cooler line.....
- Hooking up the engine and trans
- need help-will not start
- Please tell me how our door switches work...
- Bad week for my SC
- Dead Brake Pedal -- No Pressure
- open circuit in the ARC?
- fuel issues again
- Stock bottom end
- got the SC out of the mothballs.....
- Rear Brakes?
- Custom Gauge Faces...
- Exhaust Porting
- one cylinder not firing
- Rad fan(Fixed lmao...)
- GTP 2 SC sc swap out.
- Black smoke at hard acceleration
- Alternator
- ARC problems....
- Pinging or detonation under WOT
- H/G difference
- Front hub swap ?
- solid mount IC
- clutch change out
- Pilot Bearing Removal Help
- Stock fuel rail limitations
- Another "dissapointing dyno day" post.
- 5% vs 10% pulley
- new sc owner lots of probles
- Wiring for LED's
- Can an end-link cause this?
- Question for all those SC owners.
- How do I wire a car for push-button start?
- Keyless questions...
- Climate Control Question...
- Posi rebuild question...
- jbl problem
- Stock exhaust manifolds
- rear brake sticking
- A/C Compressor Differences
- carfax please ?
- Air Ride Controll?
- Are 94 manifolds the same as 95?
- Car starts but won't idle, has a miss when running.
- Paint code?...
- New Harmonic Balancer Question
- Head Gasket?
- Non SC Heads?
- poor mpg..
- fuel pressure question...
- kenne bell boost a pump/boost a spark
- Autolite XP 5144
- boost ????
- Where do I put the jumper for pulling codes?
- Anyone used Mustang seats in a SC
- What gears and diff is everyone running?
- Odometer
- 94SC+42lbinj+C&L76=?
- Replacing stock boost gauge
- Oil pressure, and steps to fix it.
- Twin-Screw Compressor conversion
- TRW Lower Control Arm replacement
- Thinking about lowering the SC, got a question for ya.
- someone help..brakelight switch ?
- ride control
- Alternator Regulator
- Auto to Manual?
- towing my SC autox car
- trunk
- crank sensor question
- HELP...Studder under Acceleration at high load...HELP
- 5-speed shifter problem
- PVC valves
- bad vibration,need help
- vaccum pump?
- Shattered slip yoke
- Vibration with BHJ
- replaced coil pack and forgot !#%*...
- smoke coming out of radiator!
- M90 Info
- Oil Pressure Drop (Found on road dead)
- New SC Owner
- Sway bar end link
- Are ARP head studs reusable?
- What Brand End Link?
- Fuel Injector Noid Light
- measurement of supercharged engine
- need help
- Damn Fuel Pump!!!
- Spark Plug question
- This one is wild. Steering problem
- Overheating FMIC and A/C revisited
- Cold Air Intake?
- White Smoke = blown head gasket
- Pulleys...
- Tranmission dropping out of O/D
- Snout Bearing questions
- Parts interchangability and swapability questions
- differences in 3.8 engines
- Something broke in my clutch pedal.. ideas?
- head gasket solutions?
- boost for 89-93 blower w/ 94-95 pulley
- Spring Code?
- Eh, OK. So, how does this work? Batt. in trunk.
- injecters, fuel line, pump questions
- Spring interchange
- more brake problems
- head gasket
- Sport shocks and springs on a SC?
- 4.10 Gear Question
- Cat or balancer????
- cleaning out block
- FMIC tubing kit?
- Question For Fellows
- Anybody ordered engine from here?
- for the love of hp should i?
- Taking Cats Off
- aftermarket parts
- High Pressure Power Steering hose
- Will 36lb injectors hold up with MP2 @15% OD?
- Valve cover replacement
- Did I break the trans
- Car bogs down just off idle?
- refill Auto tranny where?
- Addico Rear Sway Bar size..?? Help..
- maximum modifications
- My 94 SC Rides Horrible
- rides rough
- Injectors
- 93 SC Rebuild thread...
- whats up with this motor mount ?
- air/vac leak at injector?
- Do you guys trust bolt pattern conversions
- pulling the crank pulley to replace water pump ?
- rear axle questions
- passenger side exhaust manifold
- VSS pulsewidth
- What do I need to hook up an aftermarket oil press. gauge?
- porting IC tubing
- Porting SC intake
- rod, main, cam bearings
- sc half shafts
- arc relay missing
- Suggested AOD rebuild parts & mods.
- engine balance
- 1.73 Roller Rockers Arms
- Dead spot on hard acceleration
- Temp and Gauge Needle questions
- M5R2 rebuild
- how to polish IC tubes
- conversion
- Thermostat questions...
- Broken Key In Ignition
- Is a T5 tranny swap possible?
- weird sound?
- Where to find door window track?
- OD JS pulley ??
- How Far Can I Push It 91 Sc
- measurements of SC parts
- engine oil
- 5 speed Rebuild Experiences?
Powered by vBulletin® Version 4.2.5 Copyright © 2019 vBulletin Solutions Inc. All rights reserved.