View Full Version : Technical Forum
- Smoke coming from coolant reservoir after sitting for awhile?
- AC/Heater?
- ABS Pressure Switch Replacement
- new cam vacuum
- I want to Bypass my A.B.S.
- Supercharger top ?
- 89 sc pours greyish white smoke and uses coolant HELP!
- Rear suspension bushing upgrades
- bad knock in supercharger help!
- Electrical Problem :( Short Circuit?
- small finned cooler on back of radiator
- Horrible (IMO) gas mileage
- My car died
- starting & acceleration problems!
- Cant brake and the fluid res is full
- Valve Cover Bolt Size??
- Short Body Injectors
- fuel rails/regutator ?
- IRS track width
- heater selector panel light bulb
- drivers window
- Rebuilding -95 M90 Super Charger
- m5r2 rebuild
- Power window ideas....anyone have any thoughts?
- MP inlet plenum vacuum leak
- can an ambient air gauge be used as a IAT gauge?
- OBD1 code cyl6? what does this mean?
- can I use the 89-90 pintle style injectors
- ABS light
- shift linkage broke
- changed to 3:07 gears and speedo is off 10 + mph
- 1st Gen SC rear bumper question
- question about crank sensor wiring
- TB linkage?
- 89 XR7 needs help
- clicking noise, Horn blowing ???
- oil problems?
- 92 SC won't start (all of a sudden)
- F-150 m5r2
- starter relay help!!!
- need a vaccum diagram
- Half Shaft Shield / Seal
- Eletrical
- Needing some SC experts please
- For davec73
- My solution to a sagging rear bumper cover
- Slot Maf transfer function
- My Engine is finally ready to go!
- M5R2 rebuild info
- OEM Electrical Engineer Building Custom Wiring Harnesses
- Balancer and pulley decisions
- For the Mustang haters
- Rebuilding my M90....
- Cranks - No Start, smells like gas
- split port vs stock s/c heads
- To any who used a Transgo kit.
- Traction control question.
- Oil Cooler Lower Water Hose
- NO Brakes!!
- Rear Shocks
- intercooler removal
- Need Measurement for Turbo Headers
- Auto vs Manual
- cooling fan wiring
- spring swap question
- stupid clutch line
- Low boost
- 3.8 rebuild
- Strut Rod Bushing Removal
- Light knock at start up!
- ACT sensor re-location
- 5.0 tranny in SC shifts sluggish?
- Half Shafts
- Random miss/ stutter
- help
- Race Sizes for Pinion Bearings
- No start problem I need help diagnosing
- Awd
- Couple of problems with '90 SC
- mlps
- Oil pressure issue....
- heater core?
- 93 & Up Gas Tank question
- Fuel Help!!!
- Flywheel questions..
- ABS Codes 17 & 63
- 60lb injectors
- what injectors??
- no start after new starter
- Are the magnaflow direct fit cats hi flow?
- FPR or injector ?
- lucas vs siemens injectors
- Twin screw....need help
- MP Tensioner Springs
- A whole 97 miles on the new engine....its knocking like the old one....not as loud
- AOD tranny.
- magnum power intercooler
- mustang to sc
- Clutch Question
- sample tubes
- sample tubes
- balancer bolt again
- Engine wont start
- Rabs valve help
- sc cam to mustang
- maf question
- Center cap question
- So now that the engine is fixed....the tranny went to hell.
- tune change with FMIC
- What just happened?
- Rear knuckles available new
- Just wondering.
- gtp coated rotors
- Tappet Cover blew out, advice needed....
- head gaskets for a 10-12 PSI s/c
- brake conversion process
- Couple issues 90sc auto
- Motor and Trans swap
- A/C delete
- Brakes...broke
- 1990 auto, another bucking bird
- Trans Cross Member Mount
- what oxygen sensors should I use??
- Auburn Gear
- autocross suspension set
- autocross suspension setup
- Fuel Gauge Reads Low
- Cruising Vacuum Readings...MPG at 14mpg
- Cruising Vacuum Readings...
- Silicone hose for EGR?
- Installing remote start question
- Back into SCs and have a couple questions
- gonna have to tackle the intake gaskets
- 265/40/18?
- 5% SCP overdrive on 94-95 supercharger
- Pulling codes HELP!!!!
- Pulling codes HELP!!!!
- Comp Cams short travel lifters
- At what point is the stock exhaust a gasket blower?
- vibration at wot above 80mph
- Question
- Detailed help mounting FMIC
- pistons above deck
- Won't shift into 5th gear
- real oil pressure action
- MPX additional porting. MAMMOTH inlet!
- Cutouts for the exhaust
- my front mount setup.
- prof products throttle body
- no spark 92SC
- lmaf help
- Sorry, another brake thread
- 89 SC Motor
- Picked up another birdie...
- i was just thinking about my sc the last 20 years
- Belt to tight.
- blown 3.8
- Seatbelt wont return
- fuel tank questions, MKVIII
- Clutch and brake questions
- Help please tbird lx motor swap
- Quick question about the cam sensor
- 1995 Spindle LX/SC
- High NoX, misfiring badly after inspection.
- '96 brakelight/shifter problem
- 90 SC in NJ Need Tech advice/ideas
- Oh, Snap!
- Engine pull
- Quick question about trans temps
- Quick question about trans temps
- Options, before assembly
- 4.2?
- Hooked up SC tubes.
- Explosion
- 92 Supercoupe ?? BLOCK HEATER CORD??
- head question!
- Boost? How much?
- Boost? How much?
- How much boost?
- porting m90 supercharger
- porting supercharger
- Typical of blown Head Gasket?
- Need Detailed Pulley specs A.S.A.P
- Best fmic pipe kit to buy?
- Gasket Part Numbers for Head Gasket Change
- IAC voltage
- IRCM Question
- O/D Pulley Creation Project
- Ircm module
- cam specs
- Air dam for 93 SC
- Climate Control Stops Working/Battery Light
- moonroof?
- 5.0L swap questions.
- To use sealant or not,,,,,,,,,?
- v-band o-ring
- New motor new problems
- Fan voltage problem
- AOD internals
- ignition/electrical problem
- What exhaust configuration is correct?
- Double post
- Slot MAF
- Cam Talk
- Question for those running the Borla ProXS (#40349) as a resonator
- Motor Swap troubles, and advice. 90 motor into a 95 body
- Motor Swap troubles, and advice. 90 motor into a 95 body
- In cabin fuel pressure gauge
- Searched for ever and can't find the answer
- 90 and 93 rear pads
- FMIC mounting hole thread size?
- Detroit Tru-Track Install
- which block do you think is better
- Hose for the fuel injection pressure regulator
- seat control
- Ignition switch recall for 91 SC
- cylinder head question
- intake bottom plate
- power seat track??
- Waterpump nightmare.
- any ideas? i'm stumped....
- Wheel/suspension setup
- valves/cam
- Heads are off....
- oil pressure mod question.
- Crank Machining?
- exhaust drone
- water on inside of front windshield
- Pulling stub shaft bearings W/ Harbour Freight puller
- Engine Block question
- brand new clutch slipping
- Fuel Cell/Pump Pics
- Changing valve springs with heads on tool?
- Replacing coolant overflow tank
- wideband readings
- Brake Rotors
- 90sc vs 95sc wiring diagrams
- engine block
- Fuel Pump Access
- SC rotor dissasembly???
- supercharger help
- Ignition question
- Pulley size
- Stock amount of boost?
- Porting heads
- what to do?
- SC Interior lights
- auto lights
- Mandrel Exhaust Systems... rear muffler size
- ARC RADIO Problem
Powered by vBulletin® Version 4.2.5 Copyright © 2019 vBulletin Solutions Inc. All rights reserved.