Hey Guys.
I'm redoing my front suspension and ran into a problem. Hopefully some one can give me a little help here.
Everything is going smoothly until I start tightening up the nut for lower control arm to the spindle. the ball joint is turning with the nut and now I can't loosen the nut either. They both just spin and the threads are just start coming through the top of the nut that was provided by TRW.
With all the experience on this board I'm sure someone else has had this happen. Any hints out there would be appreciated.
I'm redoing my front suspension and ran into a problem. Hopefully some one can give me a little help here.
Everything is going smoothly until I start tightening up the nut for lower control arm to the spindle. the ball joint is turning with the nut and now I can't loosen the nut either. They both just spin and the threads are just start coming through the top of the nut that was provided by TRW.
With all the experience on this board I'm sure someone else has had this happen. Any hints out there would be appreciated.