fastsc92
Registered User
Finally got around to installing my Innovate stuff and was playing around with logging some channels.
I just switched over to 60lb injectors and was surprised to see 80% duty cycle at the end of a short 2nd gear pull. Does anything look out of the ordinary?
The red trace is Duty cycle
Purple Trace is A/F Ratio
Black Trace is RPM
Please note that the tune is purposely set rich(10.0) so that I could tune my MAF curve safely.
I just switched over to 60lb injectors and was surprised to see 80% duty cycle at the end of a short 2nd gear pull. Does anything look out of the ordinary?
The red trace is Duty cycle
Purple Trace is A/F Ratio
Black Trace is RPM
Please note that the tune is purposely set rich(10.0) so that I could tune my MAF curve safely.