I just got my engine rebuilt and after having it home a month I finally got the check engine light to stop coming on.
It turned out to be a vacumm hose attached to the BAP sensor. I disconnected the hose but can't find where it goes so as a test I plugged it and it runs good. I just need to turn up the idle a bit because when downshifting it stalls or comes close to every now and again
Anyways, now that it's running I heard a little chatter that I think is comign from the SC. I havea 10% pulley and new belt on it. I didn't notice this sound before and you can only hear it when the hood is open and I am leaning over the engine. I tried to get the plug out to check the oil but it is stripped.
I tried using a 5mm hex bit but that just slipped too.
Any ideas on how to get it out and are replacement plugs availalbe still?
Any help would be greatly appreciated.
It turned out to be a vacumm hose attached to the BAP sensor. I disconnected the hose but can't find where it goes so as a test I plugged it and it runs good. I just need to turn up the idle a bit because when downshifting it stalls or comes close to every now and again
Anyways, now that it's running I heard a little chatter that I think is comign from the SC. I havea 10% pulley and new belt on it. I didn't notice this sound before and you can only hear it when the hood is open and I am leaning over the engine. I tried to get the plug out to check the oil but it is stripped.
I tried using a 5mm hex bit but that just slipped too.
Any ideas on how to get it out and are replacement plugs availalbe still?
Any help would be greatly appreciated.