JasonMiller94SC
Registered User
My girlfrinds 94 SC has a lot of noise comming from the blower. I ordered a rebuld kit from Spinning Wheels and it came with instructions but I'm having some trouble.
I was able to get as far as pulling on the snout and pulling the rotor pack out of the case. Where I'm stuck is how to I get the snout off? Pully is off and instructions say to take the key way out. Any tips? After 150K miles that sucker doesn't want to move.
Next instruction says remove the snout seal. I took the clip off but I don't see how to get the seal out. I don't want to go prying around with a screwdriver and mess something up.
Also the inside of the blower case is really scrached up as well as the tips of the rotors. Is this normal? When I run my finger across the inside of the case it almost feels like sandpaper. Could it be that the snout if fine and the noise is from the rotors touching the case?
I was able to get as far as pulling on the snout and pulling the rotor pack out of the case. Where I'm stuck is how to I get the snout off? Pully is off and instructions say to take the key way out. Any tips? After 150K miles that sucker doesn't want to move.
Next instruction says remove the snout seal. I took the clip off but I don't see how to get the seal out. I don't want to go prying around with a screwdriver and mess something up.
Also the inside of the blower case is really scrached up as well as the tips of the rotors. Is this normal? When I run my finger across the inside of the case it almost feels like sandpaper. Could it be that the snout if fine and the noise is from the rotors touching the case?