TQ Question

nickleman60

Registered User
I have a stall converter for an AOD that has a bent snout where it goes into the pump, don't ask what happen as I already feel like a dumb a z z, It's brand new and I'd like to salvage it if possible so can it be fixed?
 
Last edited:
I would think the only real fix would to have a shop that rebuilds TC cut the cases apart, replace the front section weld and balance. Shouldn't cost all that much.
 
I won't charge you much to change the hub. The parts aren't very expoensive, but the converter has to be cut open to change it.
Alan
 
I have a stall converter for an AOD that has a bent snout where it goes into the pump, don't ask what happen as I already feel like a dumb a z z, It's brand new and I'd like to savage it if possible

Sounds like you already did a bit of Savage on it
 
Back
Top