PDA

View Full Version : ported heads and rockers



sprayed302
12-14-2008, 02:42 AM
Off of a 91 SC, a set of ported heads and scorpoion rockers. The heads were ported by a friend of mine, he worked at a performance shop for years. The rockers are 1.7 ratio. I would like to get $300 plus shipping for the whole set-up.

sprayed302
12-14-2008, 05:57 PM
more pics of these heads.

sprayed302
12-14-2008, 06:03 PM
pics that would not load previously.

sprayed302
12-14-2008, 06:11 PM
If I cant get more pics to download I will email all to anyone that might be interested.

SuperCharged91
12-15-2008, 05:30 PM
How much would shipping be to 67216?

sprayed302
12-15-2008, 09:07 PM
I ship through ups because Im a ups driver, I estimate the weight to be 50lbs and the cost would be $32 and would take 3 days. You can verify charges on ups.com and my zip is 32609. Thanks in advance. Greg

SuperCharged91
12-15-2008, 11:37 PM
A couple of questions. Have these been on a car since being ported? Would they have to be ground?

sprayed302
12-16-2008, 12:26 AM
Yes they were on the car for about a year, in which the car gave us alot of trouble. The brake booster went out, the balancer hub broke, then I blew a head gasket. I think these heads are just fine to bolt right up. You could put a straight edge on them to verify the are flat. I belive this is what you meant. When I replaced the balancer I also put a new supercharger belt on it. This was the first time I had ever had a new belt, I believe I went a little overboard with the boost which cause the head gasket on the exhaust side blow.

sprayed302
12-23-2008, 12:10 AM
still for sale

gjgI
01-02-2009, 12:23 PM
I have a '90 SC with 85mm TB, 42lb injectors, larger SC case and inlet plenum, headers, and several other goodies. I just bought a new long block and my question is, if i take the heads off the long block; install a stage II comp cam and BHJ balance shaft; would these heads bolt right up and work properly or would i need adjustments made? Let me know. thanks Greg

merkur
01-02-2009, 01:04 PM
If you blew a head gasket they would probably need to be shaved a bit to be perfectly flat. The only person I trust to check flatness with a straight edge is me, and I wouldn't waste my time, I would just get them shaved.
Danny

sprayed302
01-12-2009, 09:17 PM
Sold, so thanks for all of your usefull comments.