Technical questions about stock brakes.

trackjunkie

Registered User
I could see it coming for the last couple years and today I finally had a brake line rust out. They are all rusted almost everyplace on the car, and I figure if I just repair this one another one will break tomorrow. (Why is it not law that these have to be stainless? Seems like a safety issue).
Anyway, i'm planning on doing a full front to back replacement.
I have a couple questions.
First, does any one know what type of flare these use? Will I need any special dealer only voodo fittings?

Also, i'm planning to bypass the ABS system for simplicity and better stopping on snow and ice.
Therefore I need to know if the two lines coming out of the master cylinder are a left-right, front-back, or diagonals type set up.
I guess if the pressure at each hose is the same it would not matter...
 
Back
Top