piston top volume

i looked and didn't see it there, thanks

Not that spec...use the other specs and try the math.

Use the bore off that sheet and find the surface area...is that close enough?

Bore = 96.8 cm

Volume of that plane = (2 X pie X r²)

2 X 3.14 X (48.4 (cm squared)) = 0.0303952 m2
 
Last edited:
well, maybee i am really confused, but I am not sure how from any of those number you can get the CC's of the dished part of the piston
 
The pistons are at my shop, otherwise i would just figure it out. I was playing with Compression Ratio calculations here at home and thought i might get an answer to this thread right away if some one allready figured it out. No big deal. i will just measure the piston tomorrow.
 
Most of the crew is East Coast - they seem to have their milk & cookies early and sign off by this time of night, otherwise you may have gotten a specific hit by now if they know. Sorry I couldn't help.

Good luck :)
 
Back
Top