back seat removal

9

90redsc

Registered User
I am redoing the inside of a 90 XR7 split rear seat. How do you remove it. I hae tht seat section out but I can not see how the back section is removed. any help would be appreciated.
 
  1. Remove bottom cushion from car.
  2. Remove 3 bolts along back bottom edge: 2 outside lower corners and 1 bolt lower center (underneath the carpet/insulation).
  3. Fold the seatbacks down and remove the two small bolts by the upper latches.
  4. Push the entire assembly up from the bottom - 3 retaining loops/hooks along the upper edge will come out of their stays.
  5. Fold the seatbacks up and remove them w/the bolster as a unit.

It might be easier if you have someone to help remove the assembly from the car - use care to avoid damage to headliner, etc.
 
Last edited:
Thank you very much. I figured it had to be popped up, but did not see the two outer bolts you mentioned.

Thanks again
 
You must log in or register to reply here.
Back
Top