snout seal

90coug

Registered User
So I wanted to replace the seal on my SC snout. I got to this point and in the instructions I've been reading it says to now remove the seal but all I see is this

PB070131.jpg


I'm a bit confused only thing I've taken out is the retaining clip and a metal disc that had some thin plastic covers under it. What am I doing wrong? Do I need to dig deeper to find the seal, if so how do I remove the rest?
 
Last edited:
I'm a bit confused only thing I've taken out is the retaining clip and a metal disc that had some thin plastic covers under it.

That was the seal. It's not actually metal, but could seem like it at first. Just install the new seal right over the bearing and you'll be good.
 
Well it's metal, here is a pic of old and new

PB070005.jpg


PB070006.jpg


So that goes in place of that huh? Crazy it doesn't seem like these seals are very similar.
 
Last edited:
More pics, just for my own reference down the line when I forget, yes I'll forget.:eek:

PB070003.jpg


PB070002.jpg
 
Last edited:
Clean out any left over material in the snout......

Tap in the new seal and you are good to go.....:D
 
Back
Top