Anerobic Sealer on blower case, how much gap allowable

Peterdroy66

Registered User
OK
My inlet plenum to blower case has approximately .0015" gap along the top of the case surface between the bearing ends.
Will the recommended Anerobic 518 sealer secure this?
PEte
 
I've been using it with good success, but think I may go to the silicone as David suggests after a marauder I've been having trouble sealing with the anaerobic.

I don't know what my tolerance is but it's an MP3 with not alot of material at the top of the inlet to seal to the blower.
 
spec

Picked up the sealer, and on the package specifies will seal up to .010", hence I think it should be fine, I would be worried if my space was anywhere close to the spec say .008 or something.
Will advise when done.
 
Back
Top