PDA

View Full Version : anybody interested in raised sc tops?



TwoToneThunder
06-24-2009, 09:37 PM
since fast freddie dosent make these anymore and magnum powers are quiet expensive i was thinking about making a batch of these in 3/4 or 1" raised tops


id like to get a head count before i go ahead and start making these things i figure id sell them for about $125-150 shipped?


is there any interest?

92sclikenew
06-25-2009, 06:42 AM
since fast freddie dosent make these anymore and magnum powers are quiet expensive i was thinking about making a batch of these in 3/4 or 1" raised tops


id like to get a head count before i go ahead and start making these things i figure id sell them for about $125-150 shipped?


is there any interest?

i would like one but that would be a little time out from now. do you got somthing to weld aluminum now?

the-big-e
06-25-2009, 08:28 AM
I would be interested in one....

TwoToneThunder
06-25-2009, 01:20 PM
i picked up a small welder and i can buy the wire to weld aluminum if theres interest

i could make more then a 1" raised top if there was someone who wanted one but i dont think it would be better to go over an inch


im up to 3 interested people i think im going to start making some here shortly

timsmigill
06-25-2009, 05:59 PM
I'd be interested at that price. I'd like 1 inch.

JACTcoupe
06-25-2009, 09:33 PM
Im interested as well

Dahoopd
06-25-2009, 09:37 PM
Are these going to be made like the fast freddie tops? I would like to find a top that has more hat than base. Like the magnum powers.

TwoToneThunder
06-25-2009, 11:56 PM
i suppose i could look into making custom tops id be a little more tricky but it would be worth it

sinhumane
06-26-2009, 08:32 PM
any chance you could machine just a flange? i want to make an offset front outlet top, to use with a fmic.

CougarXR/7
06-26-2009, 10:57 PM
To arc weld aluminum, you will need atleast 100 amps DC using AL 43 or AL 44 rod. I usually weld aluminum at work using just arc as it's fast and not a problem on our machines.

To MIG or TIG about the same AMPS and sheilding gas.