PDA

View Full Version : Options for a shorter M90 snout? (-about 1")



DMX
07-24-2009, 04:51 PM
The FWD vs RWD lower intake mounting difference has caused the blower+lower to sit a bit too far forward on the engine - I've gotten around that for now by grinding down the little nub and reversing a stock 3.13" pulley so the ribs are centered a bit over the end of the blower casing.

Is there a slightly shorter snout section that I could use so I can make use of my other smaller pulleys? I've seen references to jag/mustang M112s, GM M90s, M62s etc but nothing concrete and no measurements for the snout length. Anyone have an idea?

thanks,
Craig

sinhumane
07-24-2009, 05:59 PM
can always have one machined down... i dont imagine it would be too unfeasible by a good shop. talk to high speed labs about it.

90blkbrd
07-26-2009, 10:24 PM
Wade at High speed labs and Ken Wagner has done it.