PDA

View Full Version : Window Regulator



Dahoopd
09-20-2009, 08:22 PM
Are the part for the regulator replaceable or do you have to replace the whole regulator. The white plastic that slides inside of the channel must be worn or bad. My window flops from side to side in the track. I have tightened/bent the track enough to hold it but the window still rides up and closes crooked at times.

Are the regulators the same for all years on the birds and cougars. I guess its time to start taking panels off at the u pull it.

the-big-e
09-20-2009, 09:18 PM
You can get a regulator from any MN-12.....

Installing it can be pain.....:rolleyes:

It helps to pre-load the regulator spring, pin it, install, and remove pin....:p

I've done it to quite a few birds.....

Dahoopd
09-20-2009, 09:25 PM
It helps to pre-load the regulator spring, pin it, install, and remove pin....:p



I was just reading your thread with the pin it, install it and remove pin technique. I wasn't sure if the plastic squares could be replaced.

the-big-e
09-20-2009, 09:51 PM
IDK.....

I always just replaced the entire assembly....