View Full Version : dirtyd0g 9.5" billet 3800 stall converter (4R70W) - $725 shipped

11-23-2009, 02:01 AM
The information about what this converter has inside is given below, taken from Alan's website (http://www.dirtydogperformance.com/converters/ford/4r70w-/-aode/9-5-inch-billet-4r70w/prod_11.html):

For those serious about racing and high rpms.
Rated for 650rwhp locked up at wide open throttle.
Damperless for a very positive clutch feel.
Small pattern is standard, large pattern available on request.

Note: This is the small pattern and will require a different flexplate from the stock MN12/FN10.

Studs installed for easier installation.
Fully furnace brazed with reinforced turbine fins for extreme durability.
Torrington bearings.
Rigid balloon plates.
Strongest billet cover in the industry.
Weighs 45lbs
Cast aluminum stator is standard, inquire about steel stator.
42 square inches of high carbon graphite clutch lining thoroughly bonded to a billet steel lockup piston.
Drain plug installed for easy servicing.

It has less than 10k miles on it. This converter gives great, hard launches and is fun to play around with. I am selling it to build up funds for another project.

The price is $725 and that INCLUDES shipping to the lower 48.

11-23-2009, 03:57 AM
If you get me the serail number "DPXXX" I will get the combination numbers so that I can tell people what it's expected stall would be in their application.