K/W rad.and block sealer...

GONE14S

Registered User
If you have a blown head gasket and are aways a way from home this stuff WILL seal it, unless there is a big hole in the block some place.

You can get it at Napa Auto parts.

My son blew a head gasket. We took the head off and had everything done to it,valves,sets,guides,seals....etc.
The block was still in the car. Now just short of cleaning the old gasket off the block, there really wasn't too much you could do with the block still in the car.
At any rate we put the head back on the block and torc. it down.
Started the car and let it run at a idle. Well needless to say it was missing on a cylinder(water getting in). White smoke out the exhaust. This is not good. We where about to pull the head when it was suggested that we try K/W rad. and block sealer.
So we followed the directions to a T , and started it up again.
Well after about 30 Sec the miss stop and the smoke went a way.
We let it run for about 45 mins. Then drained the block and added anti. freeze. We have been running the car now for three weeks and there is no sign of a blown head gasket as of yet.

So if you ever get between a rock and a hard spot, try this stuff. I'm sure it well make a believer out of you.

Kurt Sr
 
Back
Top