Installing 255 pump

90turbo1

Registered User
so I got the walbro pump the correct one. and dropped the tank, my question is that all the silver insulation on top of tank next to drive shaft was bunched up in a ball and the wires form sender/pump (the harness that is about 2 feet long) was curled up and zip tied to tank strap.

anyone know how that is supposed to be routed or better yet have a pic of there tank.

its a 1992 btw .

thanks
 
hmm strange my wires are not even close to being in that location. they are next to the front strap on pass side. there is a grey connector that is at tank and then 2 feet of wire that goes up to the pump and sendor. they were kinda just bunched together and zip tied to tank strap. there are little "christmas tree" holders on each connector like they should be secured to a hole in body or something.

that tank looks like a 1989-1991 tank, Am I correct
 
Back
Top