PDA

View Full Version : To NEEDaSCBAD...Im working on the Cougar!!



HwyStar
02-17-2010, 08:07 PM
Thanks for the good deal! Im happier than anything to have a Cougar again!

I started by pressing in new accentric bushings on the rear UCAs. These things are ALWAYS bad on every SC, XR7, and Mark VIII I have seen.

http://xcjawg.blu.livefilestore.com/y1pyDugAwXr2K7hRUCsVeFy9qxE8HBb0Xc-tQEeHlsl0NQi-NGGOrtc3CcdPwUYdjpOissrHgXLQ97sWhZhuMuRfAf60nz293M a/CougarUCA.JPG

I also put a couple of urethane UCA outters from SCP on too, that got everything tight. EVERYONE should do this.

http://xcjawg.blu.livefilestore.com/y1pohc92LoFDL3411-yHRCraJTKAJTovzuRYzSXQx1xJrHeGLm9G0R6LKFju9pZMNopt CeiLxakN_6-tNXmZ8KGJs8FIBM33QyY/CougarUCAoutters.JPG

I also put a passenger inner tie rod in. All I need now is a driver front UCA, lower ball joint, and driver inner tie rod end and the car will be alignable. CAN'T WAIT!!!

NEEDaSCbad
03-05-2010, 02:23 AM
Glad to see the car is getting the attention it needed! I hope to see the car again down the road. Good luck with the build and keep me updated!

A-man930
07-31-2010, 11:16 PM
Hey hey just ran across this thread! I'm Seth's buddy who talked him into buying that piece in the first place :p
Its awesome that someone is fixin her up man, its a cool ~~~ car that needs some love. Do keep us posted!