windshield wiper malfunction

91BLOWNBIRD

Registered User
So I did a thread search and got to the 5th page and couldn't find an answer...

My wipers, in intermittent or lo or hi, don't stop in the down position. they start to come back up first then stop most of the time a couple inches up from the bottom, but sometimes just cycle again and again until they do stop (again after going to the down position then back up a few inches).

Now they did this with the stock wiper motor and now with a replacement used wiper motor.

What do you think? anyone had or seen this problem?
 
There is a wiper control module located under the dash near the fuse block that controls the wipers....

It could be causing your problem....
 
yes, when you shut power off to the wipers it will cycle till it sees a "park" location. if it doesnt see this they will keep going with switch off. some times the park switch is nothing more than a fancy relay, some are solid state like ours i believe. i would go to the controler for wipers.
 
Back
Top