My fan burnt up today so I ordered a new motor form Advance. Now my question is since I have a Pusher fan too (former owner installed so wire may be suspect), I connect the HI and Lo speed wires to the hot on the Pusher and call that a day (currently going by standard wire colors got HI on the power and Lo on the ground for the pusher, which make me think the pusher was never working).
Was a long day today and didn't get to pin-out the pusher nor hot wire it to double check. But to make it clear to have the pusher on all the time that the puller is on is to splice the Lo and Hi together and not use a DPDT relay. If I'm looking at the EVTM right if you do that both winding on the puller will engage at the same time.
EDIT:
Just did some checking on my pusher at its a 2-speed unit so no concerns on the wiring there, though I may be putting some relays in so not to overload the circuit.
Was a long day today and didn't get to pin-out the pusher nor hot wire it to double check. But to make it clear to have the pusher on all the time that the puller is on is to splice the Lo and Hi together and not use a DPDT relay. If I'm looking at the EVTM right if you do that both winding on the puller will engage at the same time.
EDIT:
Just did some checking on my pusher at its a 2-speed unit so no concerns on the wiring there, though I may be putting some relays in so not to overload the circuit.
Last edited: