crank

hey guys, i going to order a crank from a bud of mine at autozone. but the listing says with a .666 rod bearing width.. anyone knows our rod bearing widths?
. http://www.autozone.com/autozone/ca...earchText=&categoryDisplayName=&parentId=51-0

but i am also looking at one at rockauto.com that dosent say anything about rod bearing width... this is all what that site says

{Remanufactured CRANKSHAFT; KIT INCLUDES MAIN & CONNECTING ROD BEARINGS}
1 PIECE REAR SEAL, STEEL CRANK, CAST #ES9D-6393BA

some help before the end of the day would be great..

Thats not for an SC motor is it, cause it won't last very long if it is.

Fraser

it says it is for our sc, why do you say that? that it wont work....

midnight89sc said:

it says it is for our sc, why do you say that? that it wont work....

Click to expand...

It will work and has the correct dimensions. (or at least I think)

It isn't make of the same material. This one is more than likely from a N/A 3.8 and won't last, partially due to the extra stress put on the front of the crank from the supercharger.

http://www.autozone.com/autozone/ca...earchText=&categoryDisplayName=&parentId=51-0
Is what I pull up and its casting E9TE

that was the third option in the list, will that one work? the only # i get out of my crank is 6303, must be casting #..