I am thinking about making my own intake instead of paying an arm and a leg for one that rubs the strut tower...
I was thinking about trying one of these as it looks like it would curve nicely around the strut tower http://cgi.ebay.com/ebaymotors/HOND...r_Truck_Parts_Accessories?hash=item5ad7e816e4
basically I THINK I could cut it between the two e's and that is where the MAF would mount and I think I could rotate the piece that the filter goes on so it would angle down through the hole and mount the filter behind the front bumper... Any input?
Any input?
I was planning to buy this one but I don't like how close it is to the strut tower... and I know the "expensive" one like that are the same as I seen one for sale that was "worn where it rubs the strut tower" so... http://cgi.ebay.com/ebaymotors/ws/e...&itu=UCI&otn=3&ps=6&clkid=9162471566481298096
I was thinking about trying one of these as it looks like it would curve nicely around the strut tower http://cgi.ebay.com/ebaymotors/HOND...r_Truck_Parts_Accessories?hash=item5ad7e816e4
basically I THINK I could cut it between the two e's and that is where the MAF would mount and I think I could rotate the piece that the filter goes on so it would angle down through the hole and mount the filter behind the front bumper... Any input?
Any input?
I was planning to buy this one but I don't like how close it is to the strut tower... and I know the "expensive" one like that are the same as I seen one for sale that was "worn where it rubs the strut tower" so... http://cgi.ebay.com/ebaymotors/ws/e...&itu=UCI&otn=3&ps=6&clkid=9162471566481298096
Last edited: