"built" Teksid 4.6L short block

k_schutte

Registered User
Not sure if this can go here or not... I know people do modular swaps so...


I am just seeing if there is any interest in my motor. Aluminum Teksid block from a Mark VIII, cobra crank shaft, D.S.S. forged H-beams with ARP2000 bolts, D.S.S. Forged X pistons with X-groove. Mahle piston rings, Clevite bearings. the Heads are stock "B heads" with 1996 Cobra camshafts. The block has been decked and the heads have been machined as well. Compression is right around 8.7:1, everything was done my Horn Automotive in Marion, IA. this is stock bore/stroke, it took me a LONG time to find a perfect stock bore block but that is what I wanted so that is what I got.

I also have a complete 1996 Cobra intake setup, IMRC deletes, Aeromotive fuel rails, 55lb Deka injectors, NGK plugs, Taylor plug wires, engine harness, valve covers, oil pan etc... pretty much a complete engine minus exhaust IIRC.


piston/deck: -.005
mains: .002
rods: .0021
Pistons: .0035
crank end play: .004
top piston rings 16
2nd rings 18


I have like $4000~ into it, looking to get $2800 for everything, $2500 for just the short block. The short block is all assembled the rest is parts I have gathered for the build and will be included.



46l4vdohcturbo006.jpg

46l4vdohcturbo020.jpg

46l4vdohcturbo019.jpg

46l4vdohcturbo016.jpg

46l4vdohcturbo015.jpg

46l4vdohcturbo014.jpg

46l4vdohcturbo013.jpg

46l4vdohcturbo012.jpg

46l4vdohcturbo011.jpg

46l4vdohcturbo010.jpg

46l4vdohcturbo009.jpg

46l4vdohcturbo007.jpg
 
Back
Top