PDA

View Full Version : Parts / Welding



Ira R.
09-11-2010, 01:37 PM
Anyone have any contacts where I can get a flange welded back onto the intake plenum??

It's hard to see in the picture but the plenum is no longer connected to the TB; just hanging there next to it.

http://i112.photobucket.com/albums/n161/irar_6971081/plenum_50.jpg

Miller
09-11-2010, 04:49 PM
I will trade you the contact info for a trophy

Mike8675309
09-11-2010, 06:51 PM
Anyone have any contacts where I can get a flange welded back onto the intake plenum??


Make sure that anyone that does that takes extreme care with the heat and checks the angle on the flange as it sits. They may have to machine the flange flat again after welding as well.

dboblane
04-13-2011, 06:15 PM
I can weld it but I can't machine it back to flat. I'm in the new york area

Miller
04-13-2011, 07:52 PM
this has been taken care of ;)

Ira R.
04-14-2011, 03:26 PM
Good to know though since I am going to have to completly redo my intake this spring/summer anyway. PM me some contact information so I can reach you when I have everything together.

Ira

kenewagner
04-14-2011, 03:33 PM
Good to know though since I am going to have to completly redo my intake this spring/summer anyway. PM me some contact information so I can reach you when I have everything together.

Ira
Going with the big boys and doing the 95MM TB?

Ken

Ira R.
04-14-2011, 11:27 PM
Going with the big boys and doing the 95MM TB?

Ken

Sure, why not. I managed to lighten the car by about 40 lbs so far as well so who knows what could happen ;)

Ira

XxSlowpokexX
04-15-2011, 12:26 AM
Funny..Im getting one of them as well....May have to redo the inlet and go larger with intake and MAF,,,,,,,

I was thinking...wouldnt it be a bitch if my inlet cracked and thats why Im running lik epoo.....I smoked it but who knows...