PDA

View Full Version : Snow VC-MAF Controller



Roadhawg
09-23-2010, 06:29 PM
As I look under the hood of the Thunderbird, there seems to be a lack free real estate.
This weekend I will be installing a snow system and I am trying to find a good place to mount the VC-MAF Controller. Any suggestions?

XxSlowpokexX
09-23-2010, 06:40 PM
What does it look like. I installed my Stage 3 MPG+ with the safe injection without a hitch and I have AC and everything

ricardoa1
09-23-2010, 06:45 PM
As I look under the hood of the Thunderbird, there seems to be a lack free real estate.
This weekend I will be installing a snow system and I am trying to find a good place to mount the VC-MAF Controller. Any suggestions?


I mounted my MAF controller in my glove box

Nettlesd
09-23-2010, 09:36 PM
I installed my Stage 3 MPG+ with the safe injection without a hitch and I have AC and everything

There's your answer. Install a hitch on your Thunderbird and install it on it.

nickleman60
09-23-2010, 10:54 PM
FYI.......This is going on a '95 lx 4.6 Bird

BLOWN38
09-23-2010, 11:27 PM
I put mine where the air filter is on the inner fender.

ganuolfthegrey
09-23-2010, 11:56 PM
mine is next to the air filter

Roadhawg
09-24-2010, 05:10 AM
Thanks,
I was thinking the airbox area was a good location.

fturner
09-24-2010, 10:54 AM
I generally install the controllers in the glove box unless otherwise told. Makes it easier for the tuner to adjust it while tuning.

Fraser

Roadhawg
09-26-2010, 10:46 AM
I generally install the controllers in the glove box unless otherwise told. Makes it easier for the tuner to adjust it while tuning.

Fraser

I went this route, as I only have to run one wire into the engine compartment. As luck would have it the MAF signal wire is right there going to the EEC. :)

Roadhawg
09-26-2010, 06:42 PM
I mounted the pump on the drivers side and used the stock windshield washer reservoir.

http://members.cox.net/roadhawg2/images/snowpump.JPG

ganuolfthegrey
09-26-2010, 09:02 PM
i hope you are using the anti siphion solinoind:D

Roadhawg
09-26-2010, 09:09 PM
i hope you are using the anti siphion solinoind:D

No, Anti-siphon solenoid used.
This is on a 4.6L with a SVO supercharger, my nozzle is in front of the throttlebody.

ganuolfthegrey
09-26-2010, 09:23 PM
oh ok then should be fine then:D

Roadhawg
09-27-2010, 08:53 PM
Snow system is installed............... :)

I need to give a shout out to Kurt K...
I installed the LEDs in the dash just as he did, in his install here:
http://www.sccoa.com/forums/showthread.php?t=66438&page=1&highlight=Snow

Also, Thanks to Fraser for suggesting locating the VC-MAF controller in the glove box.