16vconversion
Registered User
Hello all.. went thru the process of building an SC engine .. almost about to crank it but I wanted to see oil pressure before doing so. I'm getting foamy oil up the pushrods.. LOTS of foam. and very little pressure. it's full of 6 qts oil I expected 1 to go into filling galleys and lifters and the such.
It reads full on the stick but it's very small pressure and when I pull off the filter the oil is just complete foam. maybe partially stuck open oil pressure regulator. ?
Post some idea's because I'm not starting it until clear oil flows from the pump itself !
It reads full on the stick but it's very small pressure and when I pull off the filter the oil is just complete foam. maybe partially stuck open oil pressure regulator. ?
Post some idea's because I'm not starting it until clear oil flows from the pump itself !
Attachments
Last edited: