PDA

View Full Version : Striping down my 94 auto sc



Rpdboss
10-24-2010, 09:26 AM
I'm in progress of taking out the engine and tranny along with as much wire harness as possible to swap into my old 79 chevy monza spyder. I got the ecu side wire harness out WITHOUT cutting a single wire as well as the whole dash assembly intact. I see where the tranny harness connector to the dash below the heater controls but have no idea where it routes to in the wire loom.
I would like to know what else I need to pull to make a sc setup in that chevy. How/where the ecu and tranny receive their power .

ps. from a untouched interior to the level seen in the pics was about 75 mins of work:cool:

phils89sc
10-24-2010, 09:32 AM
I'm in progress of taking out the engine and tranny along with as much wire harness as possible to swap into my old 79 chevy monza spyder. I got the ecu side wire harness out WITHOUT cutting a single wire as well as the whole dash assembly intact. I see where the tranny harness connector to the dash below the heater controls but have no idea where it routes to in the wire loom.
I would like to know what else I need to pull to make a sc setup in that chevy. How/where the ecu and tranny receive their power .

ps. from a untouched interior to the level seen in the pics was about 75 mins of work:cool:

Was your 94 SC wrecked or something? If not, what is the reason for yanking the engine and trans to swap them into a 'gulp' Chevy?

Rpdboss
10-24-2010, 09:35 AM
rusted out! I have pie plate holes in my floor boards:mad: nothing wrong with it otherwise, trans went 2 years ago but I have a 2003 stang tranny ready to go in.