New keyless remotes??

B

BlackbirdSc94

Registered User
How hard would it be to use the keyless entry remotes from one 94 sc on another one.?? Would I have to switch computers or something:confused:
 
.Things You'll Need:
Screwdriver with rubber handle
1.1
Get into your car on the drivers' side and insert your key into the ignition switch. Turn the switch to the "Run" or "ACC" position.

2.2
Reach over your seat to the rear passenger side and locate the rear quarter panel. Pop the corner panel cover. Inside you will find your programming connector, which is a small plastic box with two wires leading to it. The connector has two pins. You will need to "jump" those pins to activate programming. Use a screwdriver with a rubber handle (to avoid shock) and momentarily touch the pins together. Your doors will lock and unlock to confirm entry into programming mode.

3.3
Push any button on your remote and your door locks will cycle again to confirm successful programming.

4.4
Turn the key in your ignition back to the "Off" position to exit programming mode.

5.5
Snap the rear quarter panel back in place to complete the task.



Read more: How to Program Keyless Entry for a 1994 Ford Probe | eHow.com http://www.ehow.com/how_7272335_program-entry-1994-ford-probe.html#ixzz18sv3cGx6
 
chickenman said:
.Things You'll Need:
Screwdriver with rubber handle
1.1
Get into your car on the drivers' side and insert your key into the ignition switch. Turn the switch to the "Run" or "ACC" position.

2.2
Reach over your seat to the rear passenger side and locate the rear quarter panel. Pop the corner panel cover. Inside you will find your programming connector, which is a small plastic box with two wires leading to it. The connector has two pins. You will need to "jump" those pins to activate programming. Use a screwdriver with a rubber handle (to avoid shock) and momentarily touch the pins together. Your doors will lock and unlock to confirm entry into programming mode.

3.3
Push any button on your remote and your door locks will cycle again to confirm successful programming.

4.4
Turn the key in your ignition back to the "Off" position to exit programming mode.

5.5
Snap the rear quarter panel back in place to complete the task.



Read more: How to Program Keyless Entry for a 1994 Ford Probe | eHow.com http://www.ehow.com/how_7272335_program-entry-1994-ford-probe.html#ixzz18sv3cGx6
Click to expand...



ok well what if you did all that and when you jump the switch it dose nothing
 
Double check that the pins are clean and that you're using something that actually conducts electricity (not painted, etc).
 
You must log in or register to reply here.
Back
Top