Can the 13" Cobra rotors be drilled to fit the smaller Tbird bolt pattern?

phils89sc

Registered User
If I wanted to go with the 13" rotors from a Cobra, can they be re-drilled to fit the factory tbird bolt pattern (93 up tbird hub)? Also, to use the 13" rotors, can the factory 16" SC wheels be used or would I have to step up to a 17" wheel? Also, to use the 13" Cobra setup, I am guessing I would have to use the Cobra caliper brackets and calipers right?

Thanks
 
Spinning Wheels also has the 13" cad plated / slotted / dimpled rotors with dual bolt pattern available. I worked with them and SP brakes to get a part # done up specifically for us, front and rear. I think you'll find they are definitely less expensive than the KVR's too.
 
Are these the rotors that were on the car we took off the lift so i could check my driveshaft, I was wondering who made them.
 
I can sell the rings separately as well, it's just the cost of the shipping that makes them expensive on their own.


cheers
Ed N.
 
Back
Top