Your experience with different slave cylinder brands

super red91

Registered User
I need to replace the slave that went out at the shootout. Rockauto has several to chose from:

Dorman
AC Delco
Rhinopac
Wagner
Brute Power
Bendix

Does anyone has any experience with any of these? Ones to stay away from? I don't want to drop the tranny again over some cheap ~~~~~.
 
I need to replace the slave that went out at the shootout. Rockauto has several to chose from:

Dorman
AC Delco
Rhinopac
Wagner
Brute Power
Bendix

Does anyone has any experience with any of these? Ones to stay away from? I don't want to drop the tranny again over some cheap ~~~~~.

Don't know if this helps or not.

A couple years ago I purchased 1 from O'Reilly's, NAPA and Advance Auto and they all ended up being the exact same part manufacturer, just labeled, and boxed differently. They all had a cheap/partially plastic throwout bearing. I ended up reusing the "Ford" one that was in the car.
 
I used the Dorman slave. I didn't see any difference. I used the new throwout bearing, which had plastic on it. For a normal street car that should be just fine.
 
Back
Top