PDA

View Full Version : cant remember for cam syncro



92sclikenew
02-26-2011, 05:56 PM
so i have this diagram but not sure if where i drop it in at?

from what i remember its at TDC? is this right?

David Neibert
02-26-2011, 06:20 PM
so i have this diagram but not sure if where i drop it in at?

from what i remember its at TDC? is this right?

The crank needs to be at 26 degrees after top dead center on cylinder #1 compression stroke, when installing the cam syncro stalk.

David

92sclikenew
02-26-2011, 07:50 PM
The crank needs to be at 26 degrees after top dead center on cylinder #1 compression stroke, when installing the cam syncro stalk.

David

thanks glad i asked im installing my motor tonight..:D to bad i had to do it in the snow.. i have to start driving the car because my daily driver taurus sho trans took a crap.:(

just glad my motor was just about ready to go in..

92sclikenew
02-26-2011, 10:33 PM
since my nos balancer dont go to 26* after tdc is the thick grove 26* after tdc

David Neibert
02-27-2011, 01:00 AM
since my nos balancer dont go to 26* after tdc is the thick grove 26* after tdc

Yes.

David

92sclikenew
02-27-2011, 10:01 AM
Yes.

David

thanks again!

TwoToneThunder
09-26-2011, 12:20 PM
does anyone have the specs of the cam syncro hold down bolt?

the old bolt broke in my old cover and id like to use something other then a torx bit head