ps high pressure hose

mike93sc

Registered User
To those that may have just replaced their power steering pump, do you remember what size the nut was for the high pressure line. I'm guessing 18 or 19. Of course i have box wrenches and sockets in those sizes, but not an open end wrench. Also, i'm guessing its ok to just swap out the evo from the old to the new pump? Is that what is usually done in this case?

Thanks in advance,

Mike
 
Its an 18mm for the High pressure line fitting.

Usuaully you swap the EVO sensor to the new pump - the pump should come with some new O rings also.

- Dan
 
Thanks very much for the info. I'll be off to sears tomorrow morning for a new 18 wrench. Yep, the new pump came with o rings and a teflon washer. I'm paranoid about leaks. Any words of wisdom and/or tricks so I get no leaks. I got the magna pure cardone pump. Hope its quiet!! I couldn't take my old one anymore. I know the ford pumps are loud, but this was crazy.

Thanks again,

Mike
 
Back
Top