PDA

View Full Version : Plastic lines?



89XR7TD
07-02-2011, 07:38 PM
Need some help identifying these plastic lines...when I removed the glove box I found them hanging there broke and the other end they plug into?

Thanks,

Tom

89XR7TD
07-02-2011, 07:40 PM
Suppose to put this in the Technical section! Sorry

Tom

RalphP
07-02-2011, 09:30 PM
They go to the SATC/EATC (temp control) on your car.

Don't know enough to tell you which one they're for, but that's where they go.

Need to fix them and reattach to get the air flowing where you want later.

RwP

XR7-4.6
07-03-2011, 12:05 AM
That's the whole junction connector for the heater box, without them you won't be able to operate any of the vacuum doors

Jeff Bratton
07-03-2011, 05:59 PM
That hard Black cable is suppose to lead into your heater controls assembly housing. It hooks onto that sliding arm the controls your temp. from cold to Hot. Without that you will not be able control your temp. settings at all. The Yellow vacuum line goes to I believe the vacuum canister just below your radio and to the left/drivers side. It, I believe controls your Defrost. The other group of lines go from your HVAC housing located basically right behind the glovebox to the left of the blower motor and connects to the back of the Heater controls assembly.

89XR7TD
07-03-2011, 06:45 PM
Thanks again guys!

You of all people should know huh Jeff! Swapping out your Dash recently:D

Thanks! I'm starting to wonder if this was the reason my car wouldn't run right, had to keep giving it gas!! Think this was my whole vacuum leak reason for car not running?

Tom

Jeff Bratton
07-03-2011, 06:46 PM
I would prolly bet some money on it... yes!