half shaft

anlo

Registered User
with the wheels off the ground should there be any play in-to-out with the half shafts there is a small amount of slack in the hub to pumpkin direction may be normal ???
 
i know for a fact that with the wheels off the ground and the Knuckle unbolted, the axle has movement under the rubber bootie. that is the fingers sliding through the endshaft part. the axle should sit in the pumpkin and not move. the shaft end should move, but you shouldnt be able to see where the oil seal sits on the axle, if thats the case, its prob not seated right, or your circlip is shot. btw make sure if you take the axle out you have a circlip to put on. good luck.
 
Back
Top