mywhite89
Registered User
Ok, I know people port the combusion side of their heads. I want to do this being that I am putting together a set of bigger valved heads and I want them to be the best they can be. I would like a bit of information if possible. I can't see just doing this without measuring the CC volume to make sure each cylinder is within 2% of each other or better. Can anyone experienced in doing this and measured cc volume let me know what kind of volume numbers I should shoot for? The heads are going on a 95 sc engine, which from my understanding have slightly higher compression ratio than earlier engines.
I'll be buying the materials this week to be able to measure cc volume, so I will know stock numbers shortly.
Chris
I'll be buying the materials this week to be able to measure cc volume, so I will know stock numbers shortly.
Chris