Rebuild costs?

socalscott

Registered User
What could I expect to spend for a basic home rebuild, as well as say with forged pistons?

What about a good shop rebuild?

Wondering what to expect for machining, i.e. alignment bore, balancing?
 
Last edited:
What could I expect to spend for a basic home rebuild, as well as say with forged pistons?

What about a good shop rebuild?

Wondering what to expect for machining, i.e. alignment bore, balancing?

Not an expert on Sc motors, yet around mn here, tank a block $40. Install cam bearings $40, resize rods 10-15 each, bore cyls $20 a hole, line bore roughly 40-70. Cut heads for bigger springs with crack test and resurface under 200 just some rough prices, cam bearings go for about $40. Rods $40 Mains $35 aftetmarket cam and springs about $425. Pistons seem to be from $300 hyper. To $500+ forged. Can get expensive fast! Just consider what your building for, driver, quick street car, strip, drag. That will help with what u can get away with to keep costs down. Hope that helps, good luck!
 
Back
Top