PDA

View Full Version : Power Distribution Box Diagram



CMac89
08-27-2011, 03:39 PM
Does anybody have one of these? I have a few things that I would like to power up by using some of those leads.

Also, I'm assuming that everything in that distribution box is only powered with the ignition switch; is that right? If so, that would be an easy source for my power block. I would also like to use it as a way to shut the motor off after a battery cut-off switch installation.

KMT
08-27-2011, 05:14 PM
Like this?

CMac89
08-27-2011, 05:28 PM
More along the lines of the wires that go to each terminal and their functions.

Jason Wild
08-27-2011, 06:27 PM
I can try and copy. My set of prints for where each wire goes

seawalkersee
08-27-2011, 09:34 PM
Here is an idea...figure out what you want/need ALL AT ONCE so I don't have to keep shipping you parts.

SWS

RalphP
08-27-2011, 10:34 PM
More along the lines of the wires that go to each terminal and their functions.

Rather like the Electrical and Vacuum Troubleshooting Manual (EVTM)?

Like the books listed here on eBay http://www.ebay.com/sch/i.html?_from=R40&_trksid=p4684.m570.l1313&_nkw=1989+Thunderbird+EVTM&_sacat=See-All-Categories ?

RwP

Mike8675309
08-27-2011, 10:37 PM
I posted one in the members area from my 90 sc.
http://www.sccoa.com/forums/showthread.php?p=956584#post956584

CMac89
08-29-2011, 09:46 AM
Does anyone know how much current the coil actually uses?

DrFishbone
08-29-2011, 01:00 PM
Does anyone know how much current the coil actually uses?

It's got to be pretty low...