Overdrive Pulley installation?

layinthesmack31

Registered User
i was wondering how i can get my overdrive pulley on without wrecking it. i have a 6 in 3 arm pulley puller like mn12 said but i started to bend the edges of the original pulley when i tried to take it off. so i stopped and decided to come ask u guys what the best way to get that pulley off is. then how do i install the overdrive pulley because it doesnt really say how on the instructions from mn12. well all the help is greatly appreciated. thanks
Matt
 
Had the same prob when I put my 10% on...I heated the pulley w/ a small propane torch,the kind you use for camping,etc...pulley slid right off,just don't get the sc shaft too hot.Replacement pulley went on same way.I think there is a keyway to line up,not sure though-it's been a while.Good luck,
z
 
Back
Top