60lb injectors
- Thread starter davec73
- Start date
BirdofPrey97
Registered User
It says they are EV1 which is the connection you need, but I dont know if they are low or high impedance.
11-18 ohms, so they will work on the impedance.
They will fit and hook up without a problem.
11-18 ohms, so they will work on the impedance.
They will fit and hook up without a problem.
davec73
SCCoA Member
For sale is a set of 8 Siemens 60lb.hr High impedence Injectors. They are Ford Racing Part #M-9593-LU60. Siemens Part #7026A09453.
These were bought new a little over a year ago and used on a turbocharged 2005 Dodge Ram Hemi for about 4 months. These injectors fit the Dodge Hemi with 1/4" spacers under the fuel rails. Also fit Ford and Chevy with EV6 connector. They probably fit many other applications as well. Check the part number to see if they fit your vehicle. They support 600-900hp on a V8 depending on your fuel pressure.
Says they are high impedance ev6 connector
These were bought new a little over a year ago and used on a turbocharged 2005 Dodge Ram Hemi for about 4 months. These injectors fit the Dodge Hemi with 1/4" spacers under the fuel rails. Also fit Ford and Chevy with EV6 connector. They probably fit many other applications as well. Check the part number to see if they fit your vehicle. They support 600-900hp on a V8 depending on your fuel pressure.
Says they are high impedance ev6 connector
BirdofPrey97
Registered User
If they are the EV6 there is an adaptor you can buy for them that will allow them to work. Not sure how much they are. Thinking about $100. So, those injectors would need to be pretty cheap to cover the adaptor charge as well.
Sorry, when I pulled them up I grabbed the 24s not the 60s.
Sorry, when I pulled them up I grabbed the 24s not the 60s.