PDA

View Full Version : Hole size of clutch master rod?



Allan
03-11-2012, 11:27 PM
Hi all. Does anyone have a spare clutch master cylinder handy? I am trying to find out the size of the hole on the end of the actuator rod. It's the part that goes onto the post on the clutch pedal and is fastened by the failure-prone plastic bushing (clutch pedal linkage clip).

I know the shoulder on the clutch pedal post is 7/16". I figure the hole should be anywhere from 15/32" to 9/16".

If anyone could verify the size, I'd appreciate it.