So I did some searching, but could not find anything that applies to my situation.....I replaced the clutch master cylinder, pushrod, and slave cylinder and bled the system. Pedal still feels soft, goes into gear fine while moving, but from dead stop, it won't go into gear. The grommet on the pushrod is still good, as far as I know, no leaks, but I will check tomorrow to see if it does leak.
What can be the cause? Pushrods (old and new) are the same length, so I'm at a loss. Parts were bought from rockauto (rhinopac brand). Thanks for your time.
What can be the cause? Pushrods (old and new) are the same length, so I'm at a loss. Parts were bought from rockauto (rhinopac brand). Thanks for your time.