Inlet plenum

Ryan A Harris

Registered User
I'm in the middle porting out my intlet. I was just wondering what would happen if I was open up the bypass passage. What, if difference would I see?
 
not a damn thing

It wont make a differance its only a bypass lets excess press pass at none boost requirements. your motor runs off the plenum this is just to return , it dont make a diff so dont waste your time unless you just like the look hell I did mine , looks good but who,s inside my plenum to see.
 
That bypass is designed to close fully and seal under boost. If you were to port the opening, then the bypass plate would no longer fit properly.
 
Back
Top