9" k&n cone filter....no fit...

89XR7TD

SCCoA Member
Started doing my bigger stuff swap sort of speak...
On the intake side first...Added the MP Inlet not so long ago
now adding the 85mm TB -3.5 CAI-C&L Maf with the
9" k&n but looks like gonna have to trim some off
the cold air pipe...looks like scp pipe.Filter sticks over
the rad support by amost 2"....something isn't right.

Tom
 
Last edited:
Also been awhile since putting on an aftermarket TB n making tps adjustments
for correct voltage...hook up a volt meter to neg side of
battery n poke the tps wires to find the volt reading
then move tps til ya get .95-.97 volts...

I Will do a search on that also LoL

Tom
 
Started doing my bigger stuff swap sort of speak...
On the intake side first...Added the MP Inlet not so long ago
now adding the 85mm TB -3.5 CAI-C&L Maf with the
9" k&n but looks like gonna have to trim some off
the cold air pipe...looks like scp pipe.Filter sticks over
the rad support by amost 2"....something isn't right.

Tom

To make mien fit I had always had to keep couplers lose and kind of squeeze thinsg into one another then sprea dthem back out again...For instance SCP pipe slips into TB, MAF slides over SCP pipe...Squeeze filter on then slide everything into position and clap couplers Shouldnt have to cut anything
 
Back
Top