PDA

View Full Version : How do I replace a starter?



syphon
11-05-2002, 08:54 PM
I was wondering if anyone had any information on how to change out a starter? I'm going to be putting new one soon and was hoping for a bit of advice or anything I should watch out for.

Also, I'm looking at buying a Haynes or Chilton manuel for my car, any recommendations?

klsoneSC
11-06-2002, 03:48 PM
Are you talking about the starter motor, if so then it is pretty straight forward. Just take the old one down and install the new one, takes like 15-30mins.

TbirdSCFan
11-06-2002, 06:58 PM
Just be sure to disconnect the battery negative cable first. There's a always hot cable running to the starter, you don't want to slip with a wrench and watch the sparks fly.

klsoneSC
11-06-2002, 11:13 PM
Ha, well that goes without saying Tbird!!! (at least I HOPE, lol)

syphon
11-07-2002, 03:13 AM
is it easy to get to? Do I have to remove anything before I can pull it off?

TbirdSCFan
11-07-2002, 04:26 AM
Very easy. Its helps to remove the passenger side wheel. Be sure to support the car fully with a jackstand on that side; don't rely solely on a jack. Also unhook the neg batt cable and then on the starter, remove the spade connector, the nut holding the cable on, then the 2 bolts holding the starter to the engine and its off. :)