Turbo IC stuff, no blower junk :p

neverfastenough

Registered User
Built a new FMIC setup, 3in pipe, tial bov, hpx maf, 25x10x3.5 core. Went a little different on this one, same short rad I have been running, except lowered a bit. Fbody/corvette style pipe look. Less than half the pipe I had before.
FB_IMG_13603690034314711_zps9abe023c.jpg

IMAG0092-1_zps58b03324.jpg

IMAG0096-1_zps9b41ec1e.jpg

IMAG0104_zpsbfcda916.jpg

IMAG0117_zps9b4bbb40.jpg

Ran outta hands :shock:
IMAG0140_zpsa2f11948.jpg

IMAG0152_zps905a585e.jpg

IMAG0143_zpsaed80828.jpg
 
IMAG0145_zps0bc2acb7.jpg

IMAG0146_zpsd4992e9a.jpg

IMAG0157_zpsbab6e1a2.jpg

IMAG0158_zps0116e6b1.jpg

IMAG0160_zpsb7eba21f.jpg

IMAG0161_zpsb268df3e.jpg


Tomorrow Ill add the slot mad flange, pointed down under the straight pipe for a clean look. I also need to bead weld the end of the straight pipe on the coupler side, even though id say its impossible for it to come off with the vband on the other end. Total of 3 couplers is very nice, fit is perfect on the other 2 so they are never blowing off. Anxious to see the difference with this setup, lighter than before and a much better core, rated to 1300+hp and 1950cfm.

Ignore the dirty nasty mess under the hood
 
Tomorrow Ill add the slot mad flange, pointed down under the straight pipe for a clean look. I also need to bead weld the end of the straight pipe on the coupler side, even though id say its impossible for it to come off with the vband on the other end. Total of 3 couplers is very nice, fit is perfect on the other 2 so they are never blowing off. Anxious to see the difference with this setup, lighter than before and a much better core, rated to 1300+hp and 1950cfm.

Ignore the dirty nasty mess under the hood


Damn! Looks really good. I have a similar idea....what have you been seeing for temps? Before this setup anyways (if you know)
 
They weren't too bad, I'd have to look at an old log.


Alrighty, just when you get a chance. (No rush) lol
I like how it resembles an F-body, looks really slick that way.
Might just have to copy you, or I'm gonna do a water to air setup, as I plan on doing some auto cross. :D
 
Nice work Corey. You planning to polish the upper pipe or just leave it natural ? Does that v-band connection have an oring ?

David
 
Well now that the IC is done I switched to the radiator. Its a small one so I wanted optimal conditions for it. I was able to keep it at 160 highway last year but red lights were about 180. So I picked up a pair of SPAL's highest flowing 11" fans and whipped up a shroud.

IMAG0216_zps22b3be95.jpg

IMAG0218_zpsc5bfd510.jpg

IMAG0223_zps0b71664d.jpg

IMAG0222_zpse5667330.jpg

IMAG0224_zpsb6309e7f.jpg


Once again, ignore the dirty mess, once Im all done fabbing, ill tidy it up under there.
 
Better make sure you run some big wire for those fans and better see what amp relay your going to need to start them.
 
Back
Top