archerman0531
Registered User
Ok, I know this isn't a mustang forum, and I'm not a member of one.
My wife has a 1994 mustang with the 3.8in it. It started pushing coolant out into the over flow and running the radiator dry. After about a month of doing this I finally got tired of it and started lookin into it. The antifreeze smelled like exhaust gas. So, I knew I had to do a set if head gaskets in it.
I had the heads machined, used fel-pro head gaskets, brand new head bolts. Everything was torqued to factory specs.
My problem is, it's still pushing coolant into the overflow an not sucking it back in. I can't figure out why. It has brand new thermostat, the radiator cap is new(15-16psi, checked it with a cap tester). Correct mixture of coolant to water, water pump seems to be workin fine, new radiator.
Needing some help with this please!
Thanks!
My wife has a 1994 mustang with the 3.8in it. It started pushing coolant out into the over flow and running the radiator dry. After about a month of doing this I finally got tired of it and started lookin into it. The antifreeze smelled like exhaust gas. So, I knew I had to do a set if head gaskets in it.
I had the heads machined, used fel-pro head gaskets, brand new head bolts. Everything was torqued to factory specs.
My problem is, it's still pushing coolant into the overflow an not sucking it back in. I can't figure out why. It has brand new thermostat, the radiator cap is new(15-16psi, checked it with a cap tester). Correct mixture of coolant to water, water pump seems to be workin fine, new radiator.
Needing some help with this please!
Thanks!