Quick Question.

Wicked SC

Registered User
Which Power Steering hose is most likely to get damaged due to bad motor mounts? Is it the Pressure or the Return hose, or both? Also, how hard is it to replace either one? Thanks.
 
I would say the pressure hose. The return line is just a peice of rubber hose where as the pressure line has a few metal line section that could have been crushed. They aren't too hard to replace, the pressure line has two fiiting on either end (they require standard open end wrenches I forget what size). The return line just has a clamp on each end.
 
My pressure line didn't get crushed, it had a small hole in it from being rubbed on one side. It cost me $15 to get it welded and has been fine since. This was not an easy job for me, simple maybe, but easy no.
 
Back
Top